How to reverse bleed motorcycle brakes – Brake bleeding is very important. It must be made when, such as, you decide to replace the brake fluid or aeronautical metal braided hoses with a model. When the use becomes prolonged or “extreme”. So, how to reverse bleed motorcycle brakes.
How to reverse bleed motorcycle brakes: Change the Liquid
We can divide the operation in 4 stages. Let’s start putting the bike on the center stand and make sure the handlebars are quite straight. This is to avoid that after removing the lid of the pan, the fluid can escape. Remove the lid. So, from now on, do not touch the brake lever more.
Now find the valve or valves, bleed, on the brake caliper. Raised in the protection of the valve rubber cap and insert a vent tube. The other end of the tube must be placed in a special container suitable for the liquid out. Then, with a wrench, unscrew the valve of one or two turns, being careful not to remove it from home.
[adrotate banner=”10″]
Actuate the brake lever gently now and the liquid begins to flow out. At the same time fill the brake pump reservoir. Careful not to ever empty the Pan because they could get air bubbles in the circuit. Maintain a constant level of the pan, until the liquid comes out of the drain valve again (that has a darker color).
At this point, tighten the valve, remove the pipe, and restore the correct level in the tank. Close the container with the two screws, tighten the valve and replace the protective cap.
How to reverse bleed motorcycle brakes: Bleeding
It is slightly more complex and need a little experience and lots of patience. I will resume the three-step process. Purging serves to cut the air bubbles present in the hydraulic system. Fill the tank and bring the liquid to the maximum level. Actuate the brake lever slowly, until you see air bubbles escape from the pan.
At this point, you can remove the hood to purge valve and how before you attach the tubing. Now it actuates the control lever until it hardens. Keeping the lever pulled, lose about half a turn the bleed valve, by draining the liquid, and quickly screw it. Now repeat the process until the liquid leaking from the valve and completely free of air bubbles. If you have suggestions about this topic, please contact us.
